DynPrompt (AutoCAD Only)

Hi,

Does anyone besides me really miss the DynPrompt (ACAD only) in BricsCAD?

It shows a reference/relative coordinate from a previous pick point to where you are going for your next pick point in the lower right of the cursor.

I submitted this as a feature request to the "higher ups" but do not believe I explained this properly.

Please see the attached screen shot,

Mike Dennis

Comments

  • @ Teradyne
    screenshot 1 = acad
    screenshot 2 = bricscad

    The only difference I see is that indeed the values get shown at the lower right of the cursor and not just at the entity itself.
    Is there a significance to it if it gets duplicated at the cursor ?

This discussion has been closed.

Howdy, Stranger!

It looks like you're new here. Click one of the buttons on the top bar to get involved!