Sections use for Modeling
How do I set my Sections
(and or Compositions ?)
So that I just get a Solid Color for Cut Faces, so that I can better recognize my geometry,
a) without any disturbing and slowing down Hatches and
b) without destroying Section's use for real BIM Sections
As much as I try (on Mac !) I don't get there,
either get empty cut faces
or overlapping faces with typical coplanar face rendering problems in OpenGL.
Also on Mac I encounter many problems with Viewport refresh although activated
(like from Drawing Explorer).
I have to switch section clip on or off and restart Bricscad in the worst case to
finally refresh all changes.
0
This discussion has been closed.