dadd1967
I'm new to Bricscad and trying to create a simple bent sheet. I am following the video tutorial. When I try to create a flange I get this error "Warning: hard edges were not detected".
Can someone help?
Comments
-
Hello dadd,
Likely you call SmBendCreate command while you should SmFlangeBase, SmFlangeEdge or SmFlangeBend. Study the tutorials in . The one you need is "Design sheet metal parts from scratch", while SmBendCreate is for "Rework an imported part".
Watch Bricsys channel for updates.
Best regards,
Egor
This discussion has been closed.
Howdy, Stranger!