lisp, place block on geometric center of polyline
I want to place a specific block on the geometric center of all polylines longer than 550mm and shorter than 650mm in my drawing. Any idea how I can do that in Lisp?
Comments
-
@Hans Hermans
Stuff like this is covered in the autodesk discussion groups much more, as the bcad groups are somewhat new.
The lisperers here learned there, and you should take full advantage of the info.
this one is a good start:
https://forums.autodesk.com/t5/visual-lisp-autolisp-and-general/trim-to-polyline-midpoint-when-selecting-unwanted-polyline-half/m-p/9567515I have a feeling you want a complete lisp though.
0 -
Looks like the OP found help over here https://cadtutor.net/forum/topic/71203-lisp-place-block-on-geometric-center-of-polyline/?tab=comments#comment-571396
0 -
Thank you for your comments and tips. My question has been answered on the cadtutor forum mentioned by Steven-g.
0
