How to change the number of segments of a cylinder in 3dconvert?

Hi guys!Does anyone know how to change the number o segments of a cylinder when we apply the command 3dconvert?I think it is related with the number of faces we see in a cylinder when shade is on.But I just cant figure out how do i increase this number in order to get smother faces.Thanks in advance.

Comments

  • I think this is very important because if we want to tranform all the solids into faces we dont have control over the number of faces in cyinders. If Bricscad does have control over this it is very bad and it must develop otherwise it is pery poor has a 3d architecture modelling tool.

This discussion has been closed.

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!