How a linetype is applied to a polyline is determined by its 'Linetype generation' property. For the polyline in your example it is enabled. The difference that you see is a linetype scale issue either caused by the PSLTSCALE or the MSLTSCALE variab…
@Anthony Apostolaros said:
Why does that extra Enter, right after the Undo command, repeat the Plot command instead of the Undo command?
That is a good question. Probably because only commands directly entered in the command bar are …
This will work in BricsCAD, but probably not in AutoCAD:
(defun c:test ( / x)
(setq x 0)
(while (< x 10000000)
(if (acet-sys-control-down) (exit))
(setq x (1+ x)…
In V18 the provided file works just fine.
If you _BmMech a file you can specify how it should be inserted by the _BmInsert command. Just change the 'Insert as' property of the component.
That dimensions in blocks can suddenly change when a block i…
\P is an Mtext format code:
\X is not mentioned on the linked page. I believe it is only used for dimensions. If \X works in AutoCAD then you should send in…
In a previous discussion with you I have defended Linux as the professional OS that it is. I have used it in the past, but I would not call myself 'the Linux guy'.
You can create a 'multi dwg layer manager' without custom dialogs I think. All you n…
Please note that the OP is talking about the _MassProp command. I can confirm the issue for V18. It is related to the LUNITS setting. The error occurs if LUNITS is 3 (Engineering) or 4 (Architectural).
Start the _dmDistance3d command without a pre-selection.
Select the 'Measurement mode' option.
And then select 'Central point'.
Select the circular edge at the bottom of the hemisphere as the first entity.
Select the bottom face of the cylinder as …
FYI: there are 'for internal use only' visual styles in a DWG. "Gouraud" is one of them.
To get some insight in the available styles type this in the Command Bar:
(entget (dictobjname (namedobjdict) "ACAD_VISUALSTYLE"))
To remove a visual style'…