Reactions
-
Re: BricsCAD is a BAD software
@Lyubov Osina the OP flew a little too far, but: bricscad broke the "If it isn't broke - don't fix it" rule since the end of V24. there a lot of problems with the GUI - see here in the foru…1 -
Re: Exporting DWG to something that ZWCAD can open?
@kanksmuso as @Its_Alive wrote - mabye TIN surface is a fearture that Zwcad can't open. to keep the topograhfy information extract the contours from the TIN surface using "tinextract" comma…1 -
Re: Reverse Direction of a Polyline
see attached lisp. PEDIT command have reverse function. using lisp save some clicks…1 -
Re: Changing TAG-name without loosing the value
Hi. If you use lisp, have a look at this post.1 -
Re: need advise on new computer spec
@Tom Foster Hi. you wrote that you have the 17" Aorus 'gamer' laptop, so I assume you use WIN11 and Nvidia 40' series graphic card (4050/4060/4070). about "where or who can I find to do tha…1
